| The hand held remote control allows easy remote
operation of your DPX or 860 by duplicating the
front panel buttons as shown in the diagram. One
major difference between front panel and remote
operation is that the individual camera buttons
have been reduced to a single button. In this case,
the first press of the "Camera" button
will cause the DPX or 860 to display camera 1.
Additional button presses will cycle the selection
through each available camera and back to camera
1. Programming the unit CANNOT be done from the
remote, but must be done from the unit's front
panel.
Please note that "Freeze" and "Sequence" share
the same button. Press and hold the "Freeze" button
to activate the "Sequencing" mode on
the DPX or 860.
Also note that the remote control may not work
properly in the presence of strong sun light.
The sun is a strong Infra-Red light source and
may interfere with the output from the remote
control.
--------------------------------------------------------------------------------
Programming your ATV® DPX, SPX, MX, SX,
860 or New 660 Remote Control
When first installing or when changing the batteries
in your DPX or 860 Remote Control, it may be
necessary to re-program it for use with the DPX
or 860. If your remote control does not appear
to work for any reason, please perform the following
steps before contacting the factory.
To program the remote control to work with the
DPX or 860:
- Ensure that batteries are properly installed
in the DPX or 860 Remote Control.
- Turn on the DPX or 860.
- On the DPX or 860, press the DISPLAY button
to return to DISPLAY mode. Then press any of
the 1-8 buttons to call up a full screen picture.
- On the remote control, press the VCR button
first, then DISPLAY. Hold both buttons together
until the indicator lights up and blinks twice.
- Enter your five-digit code. The DPX or 860
code set #1 equates to remote code 11414, and
code set #2 equates to code set 11344. The
red LED will now blink twice and the remote
control is set.
The codes are entered by using the four circular
buttons on the remote itself - NOT on the unit's
front panel.
Code
set #1
|
Code
set #2 (default)
|
FREEZE - 2 TIMES
QUADRANT - 1 TIME
FREEZE - 1 TIME
QUADRANT -1 TIME |
FREEZE - 2 TIMES
PIP - 1 TIME
QUADRANT - 2 TIMES
|
Press DISPLAY button on the remote control to
change main multi-camera displays.
Your ATV® product is factory set for Code set
#2.
NOTE: After replacing the battery, you must
reprogram the remote.
|
